Metrology.NET Demo

[CalLabSolutions]

We are setting up demos of Metrology.NET http://www.Metrology.NET and showing customers how easy it is to write state of the art automation using Metrology Blocks.

We are ready for the future with the only automated calibration solution we can develop and control from an iPad.

If you would like a demo just e-mail [email protected]

Mike

[BamaKid]

Thanks for posting. We are interested in learning more about your automation platform. I am having one of my lab managers contact you. Thanks.

[Gasinato]

I'm looking for this information, it's the information I'm looking for.

[CalLabSolutions]

We are working on the marketing message.  As a technology guy, software developer, I get into the details about how it works way too much. 

It is a new way to approach automation.  Much like how NextGen, but focused on the commercial market.

1) 17025... We can use the same spreadsheets on your SOA loaded into the Metrology.NET.
2) Same interface Manual or Automated calibration
3) Fast Automation Development I did a DMM in 3.5 Hours Fully automated.  Today a guy in the lab did a scope in 5 hours.
4) Flexible standards... Way different than anyone in the industry.
5) We can run multiple automated calibrations at the same time on a single computer with a single GPIB card.

I think those are the 5 biggest feature of the software...

Currently, we are working on a list of 500 instruments we plan to have automated by the end of the year.  Scopes, Meters, Process Calibrators.
** So if you have something you would like on the shortlist shoot me a message.

Mike
www.metrology.net

[CalLabSolutions]

We have a goal...  To have the following procedures done in Metrology.NET by the end of the year!

http://www.metrology.net/starter-pack/

I hope you all hold my feet to the fire on this project.

Mike