DA300/142-74 Autocollimator

Started by MIRCS, 07-30-2004 -- 12:12:43

Previous topic - Next topic
Print
Go Down Pages1
User actions

MIRCS

07-30-2004 -- 12:12:43
Anyone else having trouble with the cross axis check on this unit.

tater

#1
09-05-2006 -- 23:51:16
Quote from: MIRCS on 07-30-2004 -- 12:12:43
Anyone else having trouble with the cross axis check on this unit.
ensure all contact surfaces of your 470 are clean and the side to side motion of the granite is minimal.
the 142-74 is fragile and should not be shipped out for cal like they are.
i have seen them with the circuit boards completely jarred out of socket.
The large print giveth, and the small print taketh away.

MIRCS

#2
09-06-2006 -- 08:15:13
Jeez....that was a while ago.

If I remember correctly there was a alignment problem(internal)......the adjustments suck and were much worse than a T3A.
Print
Go Up Pages1
User actions