Repair 3458A Error 209: Hardware Failure: Timeout – Unable to Read and Error 1

Started by doangiau3i, 07-22-2015 -- 20:42:04

Previous topic - Next topic
Print
Go Down Pages1
User actions

doangiau3i

07-22-2015 -- 20:42:04
Hi
I have three  A3  board  A/D Converter and Inguard Logic Assembly (03458-66503 board) in Agilent 3458A. If they are used, they have errors: "Error 209: Hardware Failure: Timeout – Unable to Read"  and "Error 114: Multislope Rundown Conversion". I want to repair them. Who have solution for the described problem or repair them? Please contact with me by email [email protected]. Thank you very much.

silv3rstr3

#1
07-23-2015 -- 04:57:41
It would be easiest to take Keysight up on their trade in program.  Swap the faulty board for a brand new one and get a discount for sending the old one back.  Otherwise, RTFM!!  :-P
"They are in front of us, behind us, and we are flanked on both sides by an enemy that out numbers us 29:1. They can't get away from us now!!"
-Chesty Puller

Hawaii596

#3
07-24-2015 -- 10:09:31
I think those are only repaired by tradein with Keysight.  There was some software problems on some of the older inguard assemblies. 
"I often say that when you can measure what you are speaking about, and express it in numbers, you know something about it; but when you cannot measure it, when you cannot express it in numbers, your knowledge is of a meagre and unsatisfactory kind."
Lord Kelvin (1824-1907)
from lecture to the Institute of Civil Engineers, 3 May 1883
Print
Go Up Pages1
User actions