I am looking for documentation on the Model # 2000-350-00 preset torque
wrenches that accompanied the CDI 2000 / TFC 2000 Torque Calibration
Systems. These were almost certainly not custom made wrenches specific to
these systems and I strongly suspect they are CDI Model # 50T/ST Series (10-50
ft-lb, preset, w/ interchangeable heads) however I have no way to prove it.
Some are stamped with "preset to 550 in/lbs" while others have no assigned
preset value. If anyone has any documentation showing what series of torque
wrench this may be or has a top-notch Snap-on rep that is up for the
challenge, I would greatly appreciate it.
130 views and no replies??? I know a number of you old-timers on here remember when these were first fielded and probably still have all the original paperwork rat-holed somewhere.
Quote from: Dunnupnorth on 06-05-2017 -- 13:53:29
130 views and no replies??? I know a number of you old-timers on here remember when these were first fielded and probably still have all the original paperwork rat-holed somewhere.
129 of those views are bots.