POSITION TITLE: PMEL Technician II, Physical/Dimensional
LOCATION: Tinker AFB PMEL, OK
POSITION CLASSIFICATION: Non-Exempt
SUPERVISOR: Site Manager
HOURS: 7:00am – 4:30pm
SALARY: $31.90 per hour (IAW Union CBA increase $33.10 per hour effective 10/1/2015)
JOB SUMMARY:
The Technician II, Physical/Dimensional (henceforth "Technician II") is responsible for providing calibration and repair services on complex physical and dimensional equipment in the Precision Measurement Equipment Laboratory (PMEL).
The Technician II applies advanced technical knowledge to solve problems that typically cannot be solved solely by referencing manufacturer's manuals or similar documents. They must also exercise independent judgment in tasks, such as making circuit analysis, calculating waveforms, and tracing relationships in signal flow. They must utilize complex metrology principles to certify/repair instruments such as pressure gages, length measuring devices, vacuum systems, transducers, load cells, and torque instruments on a regular basis. Also, the Technician II uses complex test instruments, such as, high frequency pulse generators, frequency synthesizers, distortion analyzers, and complex control equipment on a regular basis.
The Technician II may be required to perform duties with overnight stays as required in order to support off-site customers within a geographical area of responsibility.
BASIC REQUIREMENTS, EDUCATION AND EXPERIENCE:
• Minimum 4 years' experience as a metrology laboratory technician. Experience to include inspecting, troubleshooting, repairing, overhauling, aligning, calibrating/certifying TMDE, and metrology laboratory working standards. Practices safe work procedures.
• Good working knowledge of calibration and maintenance of Physical, Dimensional, Mechanical, and/or Optical primary measurements standards.
• Possesses the knowledge required to read and analyze block, schematic, wiring and logic diagrams.
• Must be a US Citizen;
• Must be eligible for or have successfully completed a National Agency Check investigation within the last ten (10) years.
• Thorough understanding of the requirements of ISO 17025 and T.O. 00-20-14.
• Good written and oral communication skills.
RESPONSIBILITIES AND DUTIES:
Essential/Typical Duties:
• Maintain, repair and calibrate electronic and physical/dimensional test measurement and diagnostic equipment (TMDE).
• Perform general maintenance and overhaul procedures; uses TMDE to troubleshoot and repair equipment.
• Provide technical guidance and assistance to lower level technicians.
Non-Essential Duties:
• Other related duties as assigned.
PHYSICAL REQUIREMENTS:
- Occasionally requires Climbing, Stooping and Kneeling
- Often requires Reaching, Pulling, Pushing, Standing, Sitting, Walking, Talking and Hearing
Lifting/Moving Requirements:
- The ability to lift up to 50 pounds is required. The ability to perform repetitive hand and arm movements when calibrating certain TMDE.
All qualified candidates should submit their resume (and any other relevant documents) to Greg Stern –
Email:
[email protected]Fax:
(757) 952-3700
Mailing Address:
The Bionetics Corporation
Attn: Greg Stern
101 Production Drive, Suite 100
Yorktown, VA 23693
EQUAL OPPORTUNITY EMPLOYER: Minority/Female/Disability/Veteran
VEVRAA Federal Contractor
Employability in the U.S. only
Pre-employment drug screen required
Plus over $7.00 P/H medical opt out money. Those who already have medical, it's more like making north of $42.00 P/H!
This posting has changed to a current opening at Tinker AFB for a Mechanical Tech II.