PMEL Forum

POSITION TITLE:   Technician II, Physical/Dimensional

LOCATION:      Tinker AFB, Oklahoma City Oklahoma

SUPERVISOR:      Site Manager 

POSITION CLASSIFICATION:   FLS Non-Exempt

HOURS:         6:45 am – 3:15 pm, Monday-Friday (some overtime
            may be required)

SALARY:         $31.90 per hour (CBA)

JOB SUMMARY:
The Technician II, Physical/Dimensional (henceforth "Technician II") is responsible for providing calibration and repair services on complex physical and dimensional equipment in the Precision Measurement Equipment Laboratory (PMEL).

The Technician II applies advanced technical knowledge to solve problems that typically cannot be solved solely by referencing manufacturer's manuals or similar documents.  They must also exercise independent judgment in tasks, such as making circuit analysis, calculating waveforms, and tracing relationships in signal flow.  They must utilize complex metrology principles to certify/repair instruments such as pressure gages, length measuring devices, vacuum systems, transducers, load cells, and torque instruments on a regular basis.  Also, the Technician II uses complex test instruments, such as, high frequency pulse generators, frequency synthesizers, distortion analyzers, and complex control equipment on a regular basis.

The Technician II may be required to perform duties with overnight stays as required in order to support off-site customers within a geographical area of responsibility.


BASIC REQUIREMENTS, EDUCATION AND EXPERIENCE:
   • Minimum 4 years' experience as a metrology laboratory technician.  Experience to include inspecting, 
      troubleshooting, repairing, overhauling, aligning, calibrating/certifying TMDE, and metrology laboratory working
      standards.  Practices safe work procedures.
   • Good working knowledge of calibration and maintenance of Physical, Dimensional, Mechanical, and/or Optical
      primary measurements standards.
   • Possesses the knowledge required to read and analyze block, schematic, wiring and logic diagrams.
   • Must be a US Citizen;
   • Must be eligible for or have successfully completed a National Agency Check investigation within the last ten (10)
      years.
   • Thorough understanding of the requirements of ISO 17025 and T.O. 00-20-14.
   • Good written and oral communication skills.

ESSENTIAL FUNCTIONS:
   • Maintain, repair and calibrate electronic and physical/dimensional test measurement and diagnostic equipment
      (TMDE).
   • Perform general maintenance and overhaul procedures; uses TMDE to troubleshoot and repair equipment.
   • Provide technical guidance and assistance to lower level technicians.

NON-ESSENTIAL FUNCTIONS:
   • Perform other related duties as assigned.
PHYSICAL REQUIREMENTS:
   • Occasionally requires Climbing, Stooping and Kneeling

   • Often requires Reaching, Pulling, Pushing, Standing, Sitting, Walking, Talking and Hearing

LIFTING/MOVING REQUIREMENTS:
   • Up to 50 pounds, and must have the ability to perform repetitive hand and arm movements when calibrating
     certain TMDE.

ENVIRONMENTAL CONDITIONS
   • Normally works in an environmentally controlled area. 

All qualified candidates should submit their resumes (and any relevant documents) to:
Greg Stern – Ref: "Tinker TECH II"
Email:               
Fax:                                    
Mailing Address:            

$31.90/hr. Now that's what I'm talking about  :mrgreen:

Since when did Bionetics have the contract up there?   :-o :-o :-o
Last I heard SMR and Rothe had the contract...
They posted an open position less than 2 weeks ago...    :-o :-o :-o

Quote from: Squidley on 02-08-2015 -- 19:46:55
Since when did Bionetics have the contract up there?   :-o :-o :-o
Last I heard SMR and Rothe had the contract...
They posted an open position less than 2 weeks ago...    :-o :-o :-o

Goldbelt Falcon has most of the contract labs; SMR and Rothe werent one of the 5 companies bidding. If I made a guess I'd say Bionetics is under Goldbelt now and they have control over this lab. This position is also on their website. http://www.bionetics.com/Careers/TinkerTechnicianII.pdf

There is a reason that there are so many spots open at the Tinker AFB lab and why even more will be open soon. I refuse to be slanderous in this post but I believe honesty should be forefront. As an extremely recent employee, working there while bionetics has the contract, I have information that is not in this posting. If you'd like more please contact me at [email protected].