Honeywell is looking for a Metrology Tech II in the Rocky Mount, NC area to start 01-Nov-2014. A detailed job description is below. Interested applicants should go to Honeywell.com, careers, and apply for Req# 00260509 and/or email their resumes to:
[email protected]- Independently tests, calibrates, and repairs electrical, mechanical, electromechanical, and electronic measuring, recording, and indicating instruments and equipment for conformance to established standards, and assists in formulating calibration standards. Identifies magnitude of error sources contributing to uncertainty of results to determine reliability of measurement process in quantitative terms. Experience with Flow, Pressure and Electrical Calibrations preferred.
- Calibrate and repair specialized Honeywell and supplier built test systems including Automated Test Stations such as Vectors, STZs, CATS ll System, etc.
- Plans sequence of testing and calibration procedures for instruments and equipment, according to blueprints, schematics, technical manuals, and other specifications.
- Sets up standard and special purpose laboratory equipment to test, evaluate, and calibrate other instruments and test equipment. - - Disassembles instruments and equipment, using hand tools, and inspects components for defects. Reassembles and calibrates instruments and equipment.
- Performs other duties as assigned.
Some departments do ramp up/down quite a bit--particular engineering personnel that are dedicated to specific projects. However, there are very few layoffs in the Sustaining Engineering & Assurance Services (SEAS) division that Metrology is under. (A very low turnover rate, as well.)
We work at our Clearwater location. He is correct about our SEAS division. There are people here celebrating 35+ years employment each week.
Everyone I work with here at the Freeport location has pretty much been here since before I was born.