PMEL Forum

POSITION TITLE:   PMEL Technician
LOCATION:   MCPMEL Contract – Ellsworth AFB SD
SUPERVISOR:   PMEL Manager
CLASSIFICATION:   Non-Exempt
HOURS:   7:00am – 4:00pm, Monday through Friday (some overtime may be required)
SALARY:         $33.89/hour (CBA rate)

JOB DESCRIPTION:
The Technician is responsible for providing calibration and repair on electronic and physical/dimensional Test, Measurement and Diagnostic Equipment (TMDE).   

EXPERIENCE AND EDUCATION:
1.   Minimum 4 years' experience as a metrology laboratory technician.  Experience to include inspecting, troubleshooting, repairing, overhauling, aligning, calibrating, and certifying Test, Measurement and Diagnostic Equipment (TMDE), metrology laboratory working standards and safe work practices/procedures.
2.   Good working knowledge of calibration and maintenance of Physical/Dimensional and Electronics primary measurements standards.
3.   Possesses the knowledge required to read and analyze block, schematic, wiring and logic diagrams.
4.   Thorough understanding of the requirements of ISO 9001:2008 and
T.O. 00-20-14.
5.   Good written and oral communication skills.
6.   Must be a US Citizen.
7.   Must be eligible for or have successfully completed a National Agency Check investigation within the last ten (10) years.

RESPONSIBILITIES AND DUTIES:
Essential/Typical Duties:
•   Maintains, repairs and calibrates electronic and physical/dimensional TMDE.
•   Performs general maintenance and overhaul procedures; and uses TMDE to troubleshoot and repair equipment.
•   Utilize current technical data in the performance of all duties

Non-Essential Duties:
•   Performs other related duties as assigned.

PHYSICAL REQUIREMENTS:
Occasionally requires:
•   Climbing
•   Stooping
•   Kneeling
Often requires:
•   Reaching
•   Pulling
•   Pushing
•   Standing
•   Sitting
•   Walking
•   Talking
•   Hearing
Lifting/Moving Requirements:
•   Must have the ability to lift up to fifty (50) pounds (lbs.); must have the ability to perform repetitive hand and arm movements when calibrating certain TMDE.

Environmental Conditions:
•   Normally works in an environmentally controlled work area.

If you read the post:
"1.   Minimum 4 years' experience as a metrology laboratory technician. "

The very first line in experience and education.

Can I get the name and number for a point of contact for job specifics? If that information can not be posted on this site, please send to [email protected]. Thank you.