Is it possible to load 2 sensor files, zero and cal both sensors. Then switch between the 2 sensors. If, so where do I find the documentation for doing it.
David
You would post it on LinkedIn too..
Quote from: CalLabSolutions on 01-25-2012 -- 17:20:05
You would post it on LinkedIn too..
Of course. Not everyone is there or here.
There is an Agilent Forum out there too..
That would be a great place to give the feed back to the engineers. I have found it in my Google searchs but I have never set up an account.
Agilent forums
http://metrologyforum.tm.agilent.com/index.shtml
entry to the forum is over at left side of screen, need an account to post/reply. I have found it worth the surf.