Does anyone know where to find the Phase Specifcations for the 7mm Open and Short in the 85031B Cal Kits? They are not located in the Service Manual like the other Cal Kits.
the values themselves are stored in some of the newer network analyzers. Well probably the nominal value. I had a link about two years ago that would probably help but I don't know where to find it. It listed various delay and other values for cal kits.
Not sure if they still do it, but I know HP/Agilent used to basically buy Maury components and relabel them as HP/Agilent with their fancy part number. I personally don't have much experience digging up data on the various cal kits, but I seem to recall my coworkers banging their heads against walls trying to find specs, only to go to Maury and get them (eventually, was kinda funny).
Hope that tidbit helps. Of course, I'm sure it is stored in the PNA as well, not sure how hard it will be to get it out of it, at least in any readable format (meaning without tons of conversions).
However, I will ask my coworkers if they have something on them on Monday (seem to recall seeing one of these come through not too long ago).
Here's the links I had before. I don't know if they will help at all or not.
This is for the 85032B (N type)
http://na.tm.agilent.com/pna/caldefs/PNA/85032BE.htm
Here is the cal kit page
http://na.tm.agilent.com/pna/caldefs/stddefs.html
I'll point you toward this other forum post https://forums.tm.agilent.com/community/viewtopic.php?f=11&t=14379
or that forum in general
https://forums.tm.agilent.com/community/viewforum.php?f=72
some very smart people that work at Agilent post there.
Thanks for all the information. It will prove useful!!!!