POSITION TITLE: Physical-Dimensional Technician
LOCATION: Robins AFB, GA; Tinker AFB, OK; Maxwell/Gunter AFB, AL; Malmstrom AFB, MT
JOB SUMMARY:
Precision Measurement Equipment Laboratory (PMEL) is looking for one well rounded Physical-Dimensional calibration technician. Skills in the following measurement areas are desired, although any combination will be considered: Rings, Plugs/Pins, Gage Blocks, Surface Plate, Air Flow, Air Velocity, Tensiometers, Torque, Mass, Force, Oil and Air Pressure, and Optics.
BASIC REQUIREMENTS:
1. Minimum four (4) years experience in Test, Maintenance, and Diagnostic Equipment (TMDE) calibration and repair, preferably in a military calibration lab. Experience to include inspecting, troubleshooting, repairing, overhauling, aligning, calibrating, and certifying TMDE, metrology laboratory working standards, and safe work practices/procedures.
2. Completion of the Military DOD metrology-training program or an AA in Metrology.
3. Possess the knowledge required to read and analyze block, schematic, wiring, and logic diagrams.
4. Ability to troubleshoot and repair non-functioning TMDE.
5. A plus is having extensive knowledge of Air Force Metrology and Calibration Program requirements including Air Force T. O. 00-20-14 and T. O. 33K-1-100-1.
PHYSICAL REQUIREMENTS:
1. Lifting/Moving Requirement - up to 50 pounds. The following activities are also often required: climbing, stooping, kneeling, reaching, standing, sitting, walking, pushing, pulling, talking, and hearing.
Please send resume Donald Robertson at drobertson@smrpcola. com. Wages and benefits based on locations Wage Determination or CBA.
Quote... is looking for one well rounded Physical-Dimensional calibration technician.
I've gotten well rounded over the years but now my doctor tells me I have to lose some of that mass.