PMEL Forum

SMR Inc. is looking for all skill leaves in Physical-Dimensional areas for the Warner Robins AFB Type IIA PMEL.

Physical-Dimensional Calibration Technician
Robins AFB, GA
Type IIA PMEL

JOB SUMMARY:
Robins AFB Precision Measurement Equipment Laboratory (PMEL) is looking for well rounded Physical-Dimensional calibration technicians. Skills in the all areas of the lab including the following measurement areas are desired, although any combination will be considered: Rings, Plugs/Pins, Gage Blocks, Surface Plate, Air Flow, Air Velocity, Tensiometers, Torque, Mass, Force, Oil and Air Pressure, and Optics.       

BASIC REQUIREMENTS:

1. Minimum four (4) years experience in Test, Maintenance, and Diagnostic Equipment (TMDE) calibration and repair, preferably in a military calibration lab. Experience to include inspecting, troubleshooting, repairing, overhauling, aligning, calibrating, and certifying TMDE, metrology laboratory working standards and safe work practices/procedures.

2. Completion of the Military DOD metrology training program or have an Associate's Degree in Metrology.

3. Possess the knowledge required to read and analyze block, schematic, wiring and logic diagrams.

4. Ability to troubleshoot and repair non-functioning TMDE.

5. A plus is having extensive knowledge of Air Force Metrology and Calibration Program requirements including Air Force T.O. 00-20-14 and T.O. 33K-1-100-1.

Please send resume to [email protected].

Please post salary range and benefits for this position.

The wage is $25. 72 plus $4. 04 to be applied to the Health and Welfare.