Print Page - Torque wrench error

Title: Torque wrench error
Post by: marand on 10-11-2009 -- 02:23:50

Below 20% of FS ANSI allows an error in reading equal
to 0. 8% of torque wrench capacity. Does anyone know if such a condition exist in ISO and what is the percentage - if any - ?
Thanks for your time

Title: Re: Torque wrench error
Post by: Hawaii596 on 10-13-2009 -- 09:47:31

I have the Torque ISO at work. Running late this morning, but when I get to the lab, I'll take a look to see what it says.

Title: Re: Torque wrench error
Post by: rckmtn on 05-28-2010 -- 13:22:57

32b14-1-1-101 allows no reading in the lower 20% so if you are AF it really doesn't matter.

Title: Re: Torque wrench error
Post by: MC Devastator on 08-24-2010 -- 11:27:20

DO NOT USE BELOW 20 percent! The errors can be all over the place. When in doubt, switch to a smaller wrench that envelopes the useable range you need.

PMEL Forum

K Sections => K5/6 - Physical Dimensional => Topic started by: marand on 10-11-2009 -- 02:23:50