Welcome, Guest. Please login or register.
10-25-2020 -- 11:16:35

Login with username, password and session length

Top 10 Posters

flew-da-coup (1303)
Hawaii596 (1015)
USMCPMEL (856)
griff61 (580)
Hoopty (548)
docbyers (544)
MIRCS (535)
CalLabSolutions (521)
PMEL_DEVIL-DOG (509)
Thraxas (498)
Members
Stats
  • Total Posts: 19244
  • Total Topics: 3647
  • Online Today: 67
  • Online Ever: 242
  • (04-19-2014 -- 19:20:34)
Users Online
Users: 0
Guests: 62
Total: 62


Author Topic: Druck DPI 104  (Read 238 times)

Offline USMCPMEL

  • 7-level
  • ****
  • Posts: 856
  • Action Taken: +7/-13
Druck DPI 104
« on: 09-30-2020 -- 19:09:36 »
Is anyone a resident expert on these? I am trying to go through the calibration and nothing is working. It is a 10,000 PSI gauge reading 10050 with 10002 applied. I am using a very accurate and stable PG7302 correcting for everything. This is the third gauge I have calibrated the first 2 read fine so I know it isn't an issue with my standard. I am trying to run through the adjustment procedure and it will not take a new full scale value. I would really appreciate some help.

Offline NC-Cals

  • 3-level
  • **
  • Posts: 48
  • Action Taken: +1/-0
    • Email
Re: Druck DPI 104
« Reply #1 on: 10-12-2020 -- 14:44:23 »
Try using 9900 or 9950. It may not accept a value over 10k.

 

DISCLAIMER:  This site is not an official US Air Force site, it is intended for private use only.  It is not endorsed, in any way, by the US Air Force, the DoD, or any other governmental agency.  Additionally, all information found within this site is just that, it is NOT meant to be used in place of authorized publications.


All logos and trademarks in this site are property of their respective owner.

All forum content is the property of the respective poster, all the rest 2004-2017 by PMEL Forum.