Welcome, Guest. Please login or register.
10-19-2020 -- 23:35:59

Login with username, password and session length

Top 10 Posters

flew-da-coup (1303)
Hawaii596 (1015)
griff61 (580)
Hoopty (548)
docbyers (544)
MIRCS (535)
CalLabSolutions (521)
Thraxas (498)
  • Total Posts: 19243
  • Total Topics: 3646
  • Online Today: 75
  • Online Ever: 242
  • (04-19-2014 -- 19:20:34)
Users Online
Users: 1
Guests: 55
Total: 56

Author Topic: Datron 4000, 4000A, 4200, 470X and 480X card extenders  (Read 407 times)

Offline Volvo_nut_v70

  • Pinger
  • *
  • Posts: 7
  • Action Taken: +0/-0
    • Email
I have been doing some repairs to my 4708, in doing so I have designed and built an extender card set for the Datron 4XXX series calibrators.

It's a two card solution that covers all eight big cards. I have not yet worked out the cable extensions needed for the PA card cables for when the PA card is on the extender. I am going to look at possibly doing a breakout board for extending the cables and probing lines.

Photos of the extender card in action with the Digital/CPU card extended can be emailed on request. As you can see the extender card flips the Datron card 180 degrees to allow probing of the test points on the card. It also allows direct probing of component pads and leads using the component views in the manual. Each edge connector line has a probe hook for scope or meter probes, all 120 of them!

If you are interested in purchasing a set or have questions please drop me an email.


DISCLAIMER:  This site is not an official US Air Force site, it is intended for private use only.  It is not endorsed, in any way, by the US Air Force, the DoD, or any other governmental agency.  Additionally, all information found within this site is just that, it is NOT meant to be used in place of authorized publications.

All logos and trademarks in this site are property of their respective owner.

All forum content is the property of the respective poster, all the rest 2004-2017 by PMEL Forum.