* * *
Welcome, Guest. Please login or register.
Did you miss your activation email?
10-19-2018 -- 13:04:47

Login with username, password and session length

Top 10 Posters

flew-da-coup (1302)
Hawaii596 (996)
USMCPMEL (837)
griff61 (564)
Hoopty (547)
docbyers (544)
MIRCS (535)
PMEL_DEVIL-DOG (509)
Thraxas (498)
CalLabSolutions (492)
Members
  • Total Members: 3370
  • Latest: Cforbin
Stats
  • Total Posts: 18867
  • Total Topics: 3471
  • Online Today: 56
  • Online Ever: 242
  • (04-19-2014 -- 19:20:34)
Users Online
Users: 0
Guests: 33
Total: 33

Author Topic: Opening for Senior Metrologist at Whidley Island, WA  (Read 575 times)

Offline SMR, Inc.

  • Pinger
  • *
  • Posts: 6
  • Action Taken: +0/-0
    • Email
Opening for Senior Metrologist at Whidley Island, WA
« on: 08-02-2018 -- 15:01:14 »
Metrology Technician independently determines and performs operations required to calibrate and certify electronic, physical/dimensional measuring, and test equipment. He/she will utilize Navy calibration methods and techniques based on principles of measurement science, technical analysis of measurement problems, and accuracy and precision requirements. Metrology Technician will inspect measuring and test equipment for preventive maintenance, cleanliness, and safety requirements, analyze and interpret results of measurements and calibrations using mathematical formulas, and document result of measurements and calibrations on calibration certificates and calibration correction charts. Qualified candidates must have a well-rounded skill set in Physical Mechanical areas.
Job Requirements:
•   Minimum twelve (12) years’ experience in Physical Mechanical areas working on Test, Maintenance, and Diagnostic Equipment (TMDE) calibration and repair, preferably in a military calibration laboratory. Experience with gage-block comparator, O2 calibration, proving rings, vibration, and temperature is preferred.
•   Experience to include: Physical Mechanical areas, inspecting, troubleshooting, repairing, overhauling, aligning, calibrating, and certifying TMDE, metrology laboratory working standards and safe work practices/procedures.
•   Completion of a DOD accredited Navy/Marine/PMEL Calibration School or an Associate Degree in Metrology.
•   Completion of the Advanced Physical/Dimensional course
•   Possesses the knowledge required to read/analyze block, schematic, wiring and logic diagrams.
•   Ability to troubleshoot and repair non-functioning TMDE
•   Must be able to be able to obtain/maintain a secret clearance
Required experience:
•   Metrology: 12 years
•   Physical Mechanical: 12 years

Send resume to drobertson@smrpcola.com.

Science and Management Resources, Inc. (SMR) is an Equal Opportunity Employer. SMR will not discriminate against any employee or applicant based on gender, race, national origin, religion, sexual orientation, veteran status, age, or any other classification protected by federal, state, or local law. SMR and all subcontractors are committed and required to take Affirmative Action to employ and advance qualified women, minorities, disabled individuals, and eligible veterans as consistent with federal law.

 


DISCLAIMER:  This site is not an official US Air Force site, it is intended for private use only.  It is not endorsed, in any way, by the US Air Force, the DoD, or any other governmental agency.  Additionally, all information found within this site is just that, it is NOT meant to be used in place of authorized publications.


All logos and trademarks in this site are property of their respective owner.

All forum content is the property of the respective poster, all the rest © 2004-2017 by PMEL Forum.