PMEL Forum

K Sections => K5/6 - Physical Dimensional => Topic started by: USMCPMEL on 09-30-2020 -- 19:09:36

Title: Druck DPI 104
Post by: USMCPMEL on 09-30-2020 -- 19:09:36
Is anyone a resident expert on these? I am trying to go through the calibration and nothing is working. It is a 10,000 PSI gauge reading 10050 with 10002 applied. I am using a very accurate and stable PG7302 correcting for everything. This is the third gauge I have calibrated the first 2 read fine so I know it isn't an issue with my standard. I am trying to run through the adjustment procedure and it will not take a new full scale value. I would really appreciate some help.
Title: Re: Druck DPI 104
Post by: NC-Cals on 10-12-2020 -- 14:44:23
Try using 9900 or 9950. It may not accept a value over 10k.