* * *
Welcome, Guest. Please login or register.
Did you miss your activation email?
05-23-2017 -- 14:46:42

Login with username, password and session length

Top 10 Posters

flew-da-coup (1293)
Hawaii596 (976)
docbyers (544)
Hoopty (544)
MIRCS (532)
Thraxas (498)
griff61 (473)
CalLabSolutions (453)
  • Total Posts: 18183
  • Total Topics: 3206
  • Online Today: 67
  • Online Ever: 242
  • (04-19-2014 -- 19:20:34)
Users Online
Users: 1
Guests: 21
Total: 22

Author Topic: CDI 2000-350-0 (P/O CDI 2000)  (Read 107 times)

Offline Dunnupnorth

  • Pinger
  • *
  • Posts: 1
  • Action Taken: +0/-0
CDI 2000-350-0 (P/O CDI 2000)
« on: 05-14-2017 -- 17:27:27 »
I am looking for documentation on the Model # 2000-350-00 preset torque
wrenches that accompanied the CDI 2000 / TFC 2000 Torque Calibration
Systems.  These were almost certainly not custom made wrenches specific to
these systems and I strongly suspect they are CDI Model # 50T/ST Series (10-50
ft-lb, preset, w/ interchangeable heads) however I have no way to prove it.
Some are stamped with "preset to 550 in/lbs" while others have no assigned
preset value.  If anyone has any documentation showing what series of torque
wrench this may be or has a top-notch Snap-on rep that is up for the
challenge, I would greatly appreciate it.


DISCLAIMER:  This site is not an official US Air Force site, it is intended for private use only.  It is not endorsed, in any way, by the US Air Force, the DoD, or any other governmental agency.  Additionally, all information found within this site is just that, it is NOT meant to be used in place of authorized publications.

All logos and trademarks in this site are property of their respective owner.

All forum content is the property of the respective poster, all the rest 2004-2017 by PMEL Forum.